December 10-13, 2024 Firearms & Militaria
This lot is closed for bidding. Bidding ended on 12/10/2024
This 3-part ball or bullet mold is made from shale, as opposed to soapstone as more commonly found on Revolutionary War sites of the Continental Army. With a cavity of one-inch diameter, this mold was almost certainly made for balls used in a wall gun, rampart musket or "amusette", as they were sometimes referred to during the period. These were flintlock arms in the form of an oversized musket in terms of barrel diameter and length, intended to fire an extremely large lead ball longer distances. The British wall guns of the 18th century were much larger and heavier than their French rampart muskets. Allowing for up to 1% shrinkage rate when casting soft lead, that still leaves a ball that would be too large for a British Pattern 1738 wall gun, which had a 0.92 caliber barrel. However, this ball is admirably suited for the rifled wall guns being produced by James Hunter's Rappahannock forge, some of which had 1.10 caliber barrels--approximately a 4 bore arm--especially when one bears in mind that patching would be ideally required when loading and firing such a rifled arm. All three pieces of the mold were stacked together and two holes were drilled, one on each side of the cavity. Posts or rods, also carved and filed from shale, were sent into the largest or base piece, allowing the 3 pieces to align properly when casting. Overall dimensions when stacked, approximately 4x4x2 inches. PROVENANCE: acquired from David Gates in 2013. CONDITION: Very good to excellent and complete.